Oh no I really screwed up that arconym lol.
I meant to write pass it along (PIA) but that still would not have been the right jargon.
Thank you for the calculator link.
I will play around with the numbers so I can try & get a general range on things.
All of that information is really helpful.
A little off topic but (but it shouldn’t really mess with the thread) but I have some stuff that I would like to pass along or PIA I think was the...
Thanks for the suggestion.
I’m definitely not ready to build yet but if I go that route I will refer back to your suggestion.
I think it was you...
Thanks for the calculation methods.
I’m still a bit confused at how to work out which battery will fire my mod until the battery is close to flat...
I’m not sure if I should start a new thread for this but after cleaning my device & changing the o rings for the first time I’ve had difficulty...
So after changing my o rings for the first time I have noticed that it’s harder to open & close the holes on my tank.
I have a Nautilus 2 but I...
Oh wow you’re prepared.
I just used a sewing pin to get my old o rings off.
I guess using a pin is a bad idea if you are just cleaning and intend...
How did you work this out Noe “if I was doing that on the Aegis, then I could safely use a 13A rated battery all the way down to cut off” ?
That’s a good idea regarding the drip tips. Thanks for your input.
Using a brush to get into grooves skipped my mind. I will find a designated brush to keep for cleaning my equipment now.
Thanks for your input.
I would like some thoughts on the subject of cleaning.
Do you use hot, warm or cold water to clean your tank?
I’m just wondering...
Separate names with a comma.